Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
- After the first alarm minute, it will switch to Auto Snooze mode. Once the alarm is off, the next alarm will come again after the 10 minute snooze period is completed. This operation will be repeated 3 times. After the third alarm is finished, the alarm will shut off until the same alarm time on the next day. - To stop the buzzer alarm immediately, press the ALARM On/Off button once. Wake to Radio ( RAD) -The radio will automatically turn on when the alarm time is reached. It starts softly and becomesgradually louder. -The radio alarm will keep for 60 minutes and then will automatically shut off. -To stop the radio alarm sound immediately, press the ALARM On/Off button once. Wake to iPod® ( iPod) ® -Your docked iPod will automatically switch on when the alarm time isreached. It starts softly and becomes gradually louder. -The iPod® playback will keep for 60 minutes and then automatically shut off. ® -To stop the iPod playback immediately, press the ALARM On/Off button once. Snooze Function -When the alarm sounds, it can be temporarily stopped by pressing the SNOOZE button. The display will show the indicator “SNOOZE”. -The alarm will be delayed for 10 minutes and then come again. -This manual snooze operation can be repeated only three times. Sleep Timer -The Sleep Timer allows you to set the unit to automatically power off after a selected sleep timeis set. -To activate the Sleep Timer and select the sleep time, press the SLEEP button repeatedly. The sleep times available for choosing are: 15, 30, 45 or 60 minutes. The display will show theindicator “SLEEP”. -To switch off the Sleep Timer, press the SLEEP button repeatedly until the SLEEP indicator disappears. -To switch off the unit before the selected sleep time, press the POWER On/Off button once. -To check the current sleep time, press the SLEEP button once. 11 CARE AND MAINTENANCE -Do not subject the unit to excessive force, shock, dust or extreme temperature. -Do not tamper the internal components of the unit. -Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used. -Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. -Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. Resetting the Unit If the unit is subject to a power surge or electric shock, it is possible that the internal micro-controller may lock up and the unit will not respond to any commands from the top panel controls or remote control. 1.In this event, unplug and then reconnect the AC power plug into the wall outlet. 2.Use a straightened paper clip, toothpick or similar objects to press the RESET button located on the bottom of the main unit (see the below figure). The reset operation clears the system memory and all of your previous settings will be erased. CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT. RESET button 12 TROUBLESHOOTING GUIDE Symptom Possible Problem Solution The unit does not respond (no power) AC Adaptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit. Wall outlet is not functioning. Plug another device into the same outlet to confirm the outlet is working. iPod® does not dock properly ®Using no/wrong iPod Adaptor Make sure the dock insert is the proper fit for your iPod® iPod® does not install properly. Remove your iPod® from the dock and check for obstruction on the connectors in the dock and on your ®iPod . Then reseat it in the dock. iPod® does not respond to the speaker system iPod® is not installed properly. Remove your iPod® from the dock and check for obstruction on the connectors in the dock and on your ®iPod . Then reseat it on the dock. ®Your iPod is locked up. Please make sure that your iPod® is working properly before docking into the unit. Please refer to your iPod® manual for details. iPod® does not charge up iPod® is not installed properly. Remove your iPod® from the dock and check for obstruction on the connectors in the dock and on your ®iPod . Then reseat it in the dock. iPod® is locked up/ frozen. iPod® battery has problem. Please make sure your iPod® is working properly before docking into the unit. Please refer to your iPod® manual for details. Unit is in Radio mode Select iPod, AUX or Standby mode for iPod charging iPod unintentionally wake up in PAUSE mode It may be caused during function switching Wait for 3 minutes, iPod will enter sleep mode automatically AM band is too noisy The reception at the set location is poor. Slightly rotate the unit for the best reception. Sound is distorted Volume level is set too high. Decrease the volume. Sound source is distorted. If the iPod original sound source is of poor quality, distortion and noise are easily noticed with high-power speakers. Try a differen...