Stimmen - 2, Durchschnittliche Bewertung: 3 ( )

Hersteller: Hobart Dateigröße: 330.25 kb Dateiname: Unterrichtssprache:

Contact Hobart Corporation immediately. UNPACKING This Convenient Grill was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage. If the grill is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery. Carefully unpack the grill and place in a work-accessible area as near to its final installed position as possible. – 4 – INSTALLATION CODES AND STANDARDS The Hobart Convenient Grill must be installed in accordance with: In the United States of America: 1. State and local codes. 2. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269. In Canada: 1. Local codes. 2. Canadian Electric Code, CSA C22.1 (latest edition). Copies may be obtained from The Canadian Standard Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3. ASSEMBLY It may be necessary to install the following items. Drip Tray Grasp the tray by the black knobs on both ends and ensure the side with the higher lip is to the back. Rotate the tray a quarter turn toward the grill and set the tray into place. Then return the tray to an upright position. Spring Protection Cover Place the cover onto the spring housing and press down until securely in place. Scraper Make sure you remove the scraper prior to turning the grill ON. Store the scraper in a convenient location near the grill. Any shipping paper should be removed and discarded. PL-53449 Fig. 1 – 5 – ELECTRICAL CONNECTIONS WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES. WARNING: APPLIANCES EQUIPPED WITH A FLEXIBLE ELECTRIC SUPPLY CORD ARE PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THIS PLUG MUST BE CONNECTED INTO A PROPERLY GROUNDED THREE-PRONG RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM THIS PLUG. MODEL VOLTS KILOWATTS PHASE CIRCUIT (AMPS) HCG1 120 1.75 1 15 HCG2 220 4 1 30 HCG3 120 1.5 1 15 220 3 1 15 NOTE: The grill must be connected to a separate circuit. No other appliances must share the circuit with the grill. If shared the grill may heat more slowly than expected or blow the fuse. OPERATION WARNING: THE GRILL AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING, CLEANING OR SERVICING THE GRILL. BEFORE FIRST USE GRILL PLATES The grill is shipped with an application of machine oil on the upper and lower grill plates. This oil will need to be removed prior to the seasoning process (See page 7). Machine Oil Removal 1. Turn the grill ON (green light will light up) and turn the temperature control knob to 150°F for one minute. 2. Apply a solution of dishwashing liqu...

Herunterladen

Geben Sie zwei Ziffern: