Login:
Stimmen - 1, Durchschnittliche Bewertung: 4 ( )

Anleitung Coleman, modell p9945-700

Hersteller: Coleman
Dateigröße: 224.95 kb
Dateiname:
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


Keep away from house, garage, balconies, or eave overhangs. • Keep out of the reach of children. •Exercise the same care you would with an open fire. • Never leave unit unattended when hot or in use. •Completely extinguish fire before leaving. • Use gloves when handling or moving. Ashes can remain warm for a long time after extinguishing. • Dispose of cold ashes properly. • Do not modify in any way or use with parts not expressly approved by Coleman. Contact local authorities regarding possible burn restrictions before using product. • BURN HAZARD • Unit is hot when being used. Use care when servicing. • Keep out of reach of children. WARNING WARNING Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Assembly For use only with charcoal. LEFT LEG ASSEMBLY ¦ Align Left Leg with Bracket and attach as shown. See Blister Pack for hardware identification. Step 1 Left Leg Base L-1 Step 1a L-3 L-5 L-4 L-2 Bracket ¦ Hand tighten Nut. (Step 2) ¦ Repeat for other side. ¦ Tighten bolts and nuts. (Step 3) Step 2 Step 3 NOTE: After Left Leg is assembled the Leg should have slight resistance in movement. Left Leg Assembled Assembly (cont) RIGHT LEG ASSEMBLY HANDLE ASSEMBLY ¦ Tap one L-7 onto Wheel Axle. (Step 4) ¦ Place Lid upside down on a nonabra- See Blister Pack for sive surface to hardware identification. protect the finish and attach as shown. (Step 8) See Blister Pack for hardware identification. Be careful not to overtighten. LID ASSEMBLY ¦ Place Lid on Base. ¦ Align holes in Top Hinges with holes in Bottom Hinges then secure with ¦ Install Axle and hardware as shown. (Step 5) Bolt Hardware as shown. See Blister Pack for hardware identification. (Step 8) See Blister Pack for hardware identification. CHARCOAL GRATE ASSEMBLY ¦ Place Charcoal Grate in Base and rotate allowing Lever to slide NOTE: Clip orientation is important. See Detail 5b. through opening in Base as shown. ¦ Align Right Leg with Bracket and repeat Steps 1, 2, and 3. NOTE: After Right Leg is assembled the Leg should have slight resistance in movement. Wheel Axle L-6 Step 4 Wheel AxleL-6 Wheel A-1 Clip Clip Clip A-1 Step 5 Detail 5a Detail 5b Lid H-2 H-3 H-1 Handle Step 7 HH-1 HH-2 HH-3 Step 8 Right Leg Assembled Step 6 3 Step 9 Step 8 Step 8a Lever Instructions For Use (cont) ¦ Lift into upright position. (Step 4). 4 Assembly (cont) GRILL SET-UP IMPORTANT: ¦ Side Shelf must be attached before grill set-up. ¦ Push Clip down to release Legs from stored position. Side-Bracket Hole Shelf ¦ Extend Wheeled Legs and lock in place. Step 1 Step 2 Step 3 ¦ Align Grate Pins with holes in Base as shown. (Step 10) Hole Grate Pin Step 10 Instructions For Use Step 3a ¦ Pull front Legs back to upright position. (Step 4a) Step 4 ¦ Do not lift with hand on either end of grill. This could pinch fingers. Step 4a ¦ Extend Leg Brace to secure Legs in upright position. (Step 5) NOTE: Adjust Coupler on end of Leg Brace to ensure Legs are stable. Step 5 Step 5a Coupler Instructions For Use (cont) SIDE SHELF REMOVAL CHARCOAL ASH COLLECTION SYSTEM (cont) 5 CHARCOAL ASH COLLECTION SYSTEM IMPORTANT: Be sure Ash Pan Lid is off before lighting charcoal and throughout cooking process. ¦ When finished cooking, press Charcoal Grate Lever down and slide to the right. ¦ If all charcoal does not fall through grate, repeat step as necessary. ¦ Slide lid through Ash Pan channels over used coals and ashes to seal container. ¦ Remove Ash Collection System as shown. Ash Pan Lid ¦ Use handle to carry Ash Pan. CAUTION: It is advisable to wear a glove to prevent injury or burns. ¦ Properly discard ashes. ¦ Use handle on Side Shelf to transport grill. Make sure Clip is latched to lock legs. CAUTION: Do not attempt to move grill with lighted charcoal in unit. Grill Transport ¦ Pull back tab to release shelf and lift to remove. Clip Accessories Carry Bag 9945-100 Grill Cover 9945-102 Griddle 9945-3171 Visit us at Or Call us at 1-800-835-3278 Notes 6 Replacement Parts Parts List No. Qty. Description Part No. 1 1 Lid Assembly 9945-1061 2 1 Handle 9945-1281 3 1 Cooking Grate Assembly 9945-3161 4 1 Charcoal Grate Assembly 9945-3151 5 1 Base Assembly 9945-2331 6 1 Left Leg Assembly 9945-2341 7 1 Ash Pan Assembly 9945-2321 8 1 Ash Pan Lid Assembly 9945-2311 7 1 2 3 4 5 6 9 7 8 10 11 12 13 9 1 Side Shelf Assembly 9945-2361 10 1 Right Leg Assembly 9945-2351 11 2 Wheel 9945-2201 12 1 Axle 9945-1121 13 1 Clip 9945-1751 14 1 Blister Pack (Hardware) 9...

Dieses Handbuch ist für folgende Modelle:
Konvektionsöfen - 9945-700 (224.95 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien