Login:
heruntergeladen wurde: 7   Dateigröße: 2 mb   Hersteller: Stearns Recreational  
Kategorie: Rettungswesten
@name

APPROVAL CONDITIONS and CARRIAGE REQUIREMENTS This inflatable belt is approved by the U S Coast Guard as a Type V User Assisted Personal Flotation Device (PFD). It is APPROVED ONLY WHEN WORN for use as a Flotation Aid, Type III PFD for recreational use on calm inland waters. It is not approved for water skiing or other high-speed activity. This inflatable was designed to be more comfortable and less restrictive to wear than inherently buoyant PFDs. When used and serviced according to this owner’

heruntergeladen wurde: 6   Dateigröße: 434 kb   Hersteller: Attwood  
Kategorie: Rettungswesten
@name

bits. • Screwdriver and two #10 x 3/4' (19mm) long pan head stainless screws. • Suitable marine sealant. • 2-conductor, 14-gauge wire for connection to switch and power supply. • Fuse holder with 3.0-amp (maximum) fuse. • Push-button switch (Attwood Part No. 14396). LOCATION Mount horn above deck in an area not directly exposed to wave action. MOUNTING INSTRUCTIONS 1. Place horn in desired location. Use base to mark pilot holes for mounting screws. 2. Drill two Vs" (3mm) pilot holes. I

heruntergeladen wurde: 6   Dateigröße: 434 kb   Hersteller: Attwood  
Kategorie: Rettungswesten
@name

Look to Attwood for quality replacement parts and marine accessories. SAVE THESE INSTRUCTIONS Form Number 69309 Rev. B 03-10 REQUIRED FOR INSTALLATION • Drill with Vs" (3mm) and W (6mm) dia. bits. • Screwdriver and two #10 x 3/4' (19mm) long pan head stainless screws. • Suitable marine sealant. • 2-conductor, 14-gauge wire for connection to switch and power supply. • Fuse holder with 3.0-amp (maximum) fuse. • Push-button switch (Attwood Part No. 14396). LOCATION Mount horn above deck

heruntergeladen wurde: 6   Dateigröße: 434 kb   Hersteller: Attwood  
Kategorie: Rettungswesten
@name

If necessary drill a third W (6mm) diameter hole for routing power wires. (See Figure 1.) 3. Attach power wires to suitable switch, 3.0-amp fuse, and power source. 4. Insert mounting screws through base and the supplied rubber gasket. Use #10 stainless screws to fasten horn to deck. Apply marine sealant to horn base and wire hole. © 2003 Attwood Corporation 1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

heruntergeladen wurde: 6   Dateigröße: 871 kb   Hersteller: Stearns Recreational  
Kategorie: Rettungswesten
@name

1339 and 1341 I. APPROVAL CONDITIONS and CARRIAGE REGULATIONS This inflatable PFD is approved by the U.S. Coast Guard for use as a Type V Humidity Sensitive Personal Flotation Device (PFD) with Type II performance. IT IS APPROVED ONLY WHEN WORN. It is not approved for water skiing or other high impact, high speed activities. This inflatable PFD was designed to be more comfortable and less restrictive to wear than inherently buoyant PFD’s. When worn, used, and serviced according to this owner’s m

heruntergeladen wurde: 4   Dateigröße: 871 kb   Hersteller: Stearns Recreational  
Kategorie: Rettungswesten
@name

Inspect the inflatable portion of the PFD in accordance with Care and Maintenance Instructions. V. CARE AND MAINTENANCE INSTRUCTIONS GENERAL PRODUCT LIFE EXPECTANCY The reliability and service life of this PFD depends greatly upon how it is used and cared for. Avoid storing PFD in direct sunlight. Sunlight contains ultraviolet radiation that weakens synthetic materials. Prolonged exposures to high temperatures and high humidity may shorten service life of this PFD. While it is known that these e

heruntergeladen wurde: 10   Dateigröße: 950 kb   Hersteller: SOSpenders  
Kategorie: Rettungswesten
@name

Coast Guard for use as a Type III Personal Flotation Device (PFD). It is not approved for water skiing or other high impact, high speed activities. This inflatable PFD was designed to be more comfortable and less restrictive to wear than inherently buoyant PFDs. When worn, used and serviced according to this owner’s manual, this PFD can greatly increase your chances of survival in the water. Not recommended for non-swimmers or weak swimmers. Users of inflatable PFDs must be at least 16 years old

heruntergeladen wurde: 5   Dateigröße: 3 mb   Hersteller: Stearns Recreational  
Kategorie: Rettungswesten
@name

6 DONNING and INFLATION INSTRUCTIONS After completing the pre-donning check, follow these instructions to don, inflate and adjust the PFD for maximum performance. 1. Loosen Shoulder Straps. Insert left arm between back strap and deflated vest (See fig.1). Pull vest on over your head (See fig.2). Pull buckle to front so you can see it. Buckle and adjust by pulling on free end of the belt. Secure the excess strap by tucking it under the belt. Always position the belt with the center window in fron

heruntergeladen wurde: 8   Dateigröße: 3 mb   Hersteller: Stearns Recreational  
Kategorie: Rettungswesten
@name

Be sure it is smooth and has no holes or scratches. There is a gross weight on the cylinder. If you have any questions about cylinder integrity, weigh the cylinder on a small scale, such as a postage scale. Compare the weight printed on the cylinder to the actual weight. If they do not match, get another cylinder. STEP 5 Screw new cylinder in a clockwise direction firmly into the inflator. Do not over-tighten, but ensure the fit is tight. STEP 6 Check the inflator arming indicator every boating

heruntergeladen wurde: 13   Dateigröße: 167 kb   Hersteller: Harbor Freight Tools  
Kategorie: Rettungswesten
@name

SAVE THESE INSTRUCTIONS Work Area Keep your work area clean and well lit. 1. Cluttered benches and dark areas invite accidents. Keep children and visitors away while installing and operating. 2. Distractions can cause you to lose control. Never allow children to play with the Oooga Horn. Avoid body contact with grounded surfaces such as pipes, radiators, ranges, 3. and refrigerators. There is an increased risk of electric shock if your body is grounded. Do not expose the Oooga Horn to rain or we





Kategorien