Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
For a younger child, the shoulder straps should be positioned through the lower sewn-in loops on the seatback. For a young child that is tall, the shoulder straps may be positioned through the upper sewn-in loops on the seatback. For a taller child, use the shoulder straps WITHOUT positioning them through these sewn-in loops. To re-position the shoulder straps, unbuckle them from the harness buckle and feed these straps through the sewn-in loops, insuring that they are not twisted. Re-buckle the shoulder straps onto the harness buckle to secure them. • Bring the seat belt around the child’s waist and insert the male ends of the waist/shoulder buckle into the female buckle. Ensure that they snap into place. See Figure 21. Tighten the waist belt to be snug around the child’s waist. • Both the shoulder straps and the waist/crotch straps may be adjusted using the sliding buckles on these straps. See Figures 22 and 23. ! WARNING Avoid serious injury from falling or sliding out. Always use the seat belt and harness. Figure 20 Figure 21 Figure 22 Figure 23 Caboose Stand-On Tandem Instruction Manual Page 8 Seatback Positioning The front seat has two positions. The fully upright position should only be used for a child that is at least 6 months old. • To place the seat in the upright position, push the bar on the rear of the seat toward the front of the stroller and rotate the seatback towards the front of the stroller until this bar is locked in its LOWEST position. See Figure 24. • To recline the seat, pull the bar on the rear of the seat toward the rear of the stroller and rotate the seatback down until this bar is again in its LOWEST position. See Figure 25. Figure 24 Figure 25 ! WARNING Whether the seatback is upright or reclined, ALWAYS make certain that the rotating bar behind the seatback is in its LOWEST position before placingthe child into the seat. Using the Stand-On Platform • Push the bench seat to its most forward position. • Position the canopy to its most forward position. • Position the child on the platform on the back of the stroller. Be sure that the child is facing forward and BOTH of their hands are holding the handles on the frame. • Be sure that BOTH of the child’s feet are fully on the platform at all times. • You may need to adjust the position of the seatback to allow for more room for the child to stand. Page 9 Caboose Stand-On Tandem Instruction Manual ! WARNING The rear stand-on platform and the rear bench seat are designed for a childthat is at least 2-1/2 years old but LESS than 44 inches tall and less than 45 lbs. Use of the stroller with two children weighing more than 45 pounds each, orchildren totaling more than 90 pounds, will cause excessive wear and stresson the stroller and may cause a hazardous unstable condition. NEVER use this stroller to carry more than 2 children at the same time. NEVER allow a standing child to use the canopy as a hand hold. Using the Rear Bench Seat • Push the bench seat to its most rearward position. NOTE: that there are webbing straps attached to the bottom of the rear seat pad. These straps will lock the seat into the most rearward position. To lock the seat, pull the straps from EACH side of the pad and loop them around the frame as shown, then snap them together. See Figure 26. To slide the seat forward, undo EACH snap and reattach the webbing to the underside of the seat pad using the hook and loop attachments. • Position the canopy to its most forward position. • Unlatch the waist buckle by squeezing the latch releases on both sides of the buckle and removing the male ends of each buckle. • Have the child sit on the bench seat facing backward with their feet on the form. • You may need to adjust the position of the seatback to allow for more room for the child to sit. • Place the crotch strap between the child’s legs. • Bring the seat belt around the child’s waist and insert the male ends of the waist buckle into the female buckle. Ensure that they snap into place. See Figure 27. • Adjust the seat belt to be snug around the child’s waist. • Be sure that the BOTH of the child’s feet are fully on the platform at all times. • Be sure that BOTH of the child’s hands are holding the handles on the frame. !WARNING Figure 27Figure 26 NEVER allow a rear seated child to use the canopy as a hand hold. Caboose Stand-On Tandem Instruction Manual Page 10 Using the Stroller as an Infant Car Seat Carrier • To use the stroller to carry an infant car seat carrier, you must replace the Front Tray with the Car Seat Carrier Support. • Remove the Front Tray by pressing in on the lock tabs and pulling the tray off the brackets. Store the tray in a convenient place for later use. • Line up the female fittings on the Car Seat Carrier Support to the male fittings on the front of the stroller and push inward until the fittings snap into place. See Figure 28. Pull outward on both sides of the support to be sure both are snapped securely in place. • Push the canopy to its m...
Dieses Handbuch ist für folgende Modelle:Kinderwagen - 40X Series (850.24 kb)